B2B technical product support for surface preparation, finishing, painting and waterproofing
Product Finder0Enquiry List
SunChem Lunaris Wellspray-A9 texture spray gun in its retail box
Spray Guns & Equipment

Texture Spray Gun

Wall and ceiling texture application

The Texture Spray Gun applies heavy-bodied texture material to walls and ceilings, using a larger orifice and lower atomisation than a finishing gun so the material lands as discrete particles rather than a continuous film. Adjustable controls set pattern size across a range from fine knock-down to coarse finishes. Texture work depends heavily on consistent gun distance and material consistency, so establish both on a test board before working on the surface.

Suitable context
Wellspray-A9 (Type A9)Aluminium gravity cupBrass air inlet1 piece

Common applications

  • Application of compatible texture materials
  • Prepared walls and compatible project surfaces
  • Trade and project enquiries across India
Product overview

Where this product fits

Texture spray gun for decorative wall and ceiling finishes, with adjustable pattern control from fine to coarse.

Key benefits

  • Adjustable controls for fine to heavy texture styles.
  • Even spray gives uniform adhesion and appeal.
  • Lightweight and ergonomic for fatigue-free use.
  • Engineered for durability across frequent projects.
  • Suits drywall, plaster, and ceiling enhancements.

Selection and use checkpoints

  • Choose mesh appropriate to the coating
  • Do not force unsuitable high-viscosity material
  • Use clean handling procedures

Pro tip

Practice on cardboard to perfect your texture before tackling large surfaces.

Technical information

Product specifications

Suitable surfacePrepared walls and compatible project surfaces
Primary purposeApplication of compatible texture materials
Available formats1 piece
Technical detailsConfirm material, tool and process compatibility from the current product label or with SunChem Lunaris before use.
Country of originIndia

Sizes & formats

Standard

Compatibility

Walls, ceilings, drywall

Purpose

Texture application

Application route

Spray-equipment setup and test sequence

  1. Confirm the coating and nozzle requirement

    Begin with the coating supplier’s stated viscosity, nozzle and air recommendations.

  2. Check the complete air path

    Verify clean, dry compressed air, suitable hose and filtration before filling the gun.

  3. Test the spray pattern

    Adjust air, fluid and fan controls on a test panel before coating the workpiece.

  4. Clean promptly after use

    Follow the current equipment and coating instructions before material cures in the fluid path.

Further reading

Related technical guides

How to Select a Spray-Gun Nozzle SizeRead →How to Clean an HVLP Spray GunRead →
Practical guidance

Paint Funnel Filter FAQs

What types of textures can I create with this spray gun?

The Lunaris Texture Spray Gun allows for a variety of finishes, including knock-down, orange peel, and popcorn textures. Adjusting the nozzle settings and air pressure lets you customize the texture density.

Can I use this with standard drywall compounds?

Yes. It works well with pre-mixed or water-based drywall compounds, as well as other texturing materials like stucco and acoustic coatings. Check the material is properly thinned to avoid clogging.

What air compressor specifications are needed?

For best performance, use an air compressor with at least **4-6 CFM at 40-60 PSI**. Higher PSI provides more aggressive texture application, while lower PSI allows for finer details.

How do I prevent clogging?

To prevent clogging, properly mix and strain texture materials before use. Fitting a Lunaris Water Separator upstream gives a dry air supply, reducing the risk of material buildup.

How do I clean the Lunaris Texture Spray Gun?

Immediately after use, rinse the gun with warm water or an appropriate solvent. Disassemble and clean the nozzle and internal components to maintain consistent performance.